Avital Phoenix 2 Installation Manual download pdf (Page 16)

Programmable Features

All system and remote control programmable features are accomplished by

turning the ignition key to the "ON" position or starting the engine and flicking

the valet switch on and off a preset number of times. The siren will chirp for

audible programming confirmation.

The system also allows you to add new remote controls in one step, delete lost

or stolen remote controls or rearrange the factory preset remote control

functions.

1. Remove the system from Protected or Remote-Controlled Valet Mode.

Programming cannot be accessed while the system is in Valet Mode

indicated by the LED on solid red.

2. Select the feature you wish to program from the "Programming Table for

System Features" or the "Programming Table for Remote Controls" on

pages 15-16. Note the number of chirps associated with that feature.

3. Turn the ignition key to the "ON" position.

4. Within 10 seconds, begin flicking the valet switch on and off. The siren

will chirp once each time you flick the switch on then off.

5. Continue flicking the switch on and off, counting the number of chirps.

NOTE: Stop when you reach the number of chirps associated with your

chosen feature.

6. Follow the "Secondary Action." You will hear a number of chirps to

confirm that you have changed the setting of that feature.

7. Turn the ignition key "OFF."

8. Repeat steps 1-7 for any other feature you wish to program.

Phoenix2 Rev. A - Installation Manual 0399

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

No comments

Avital Phoenix 2 Installation Manual Page 16